-
Net P Status LED
Multicolour LED. Illuminates in Switched mode or Redundant mode:
-
Green (Solid) – Primary Link active (DHCP)
-
Blue (Solid) – Primary Link active (Static IP)
-
Off – No network connection
-
-
Sync P Status LED
Multicolour LED. Illuminates in Switched mode or Redundant mode:
-
Blue (Solid) – Confirms card is a Dante PTP leader; the card is set (via Dante Controller) to generate the Dante clock which will be used by other units
-
Green (Solid) – Confirms card is a Dante PTP follower; the card will sync to the clock embedded in the incoming Dante bitstream
-
Red (solid) – No PTP sync
-
-
Net S Status LED
Multicolour LED:
-
Green (Solid) – Secondary Link active (DHCP)
-
Blue (Solid) – Secondary Link active (Static IP)
-
Off – No network connection
-
Purple (Solid) – Indicates card is in Switched mode
-
-
Sync S Status LED
Multicolour LED. Illuminates in Redundant mode only:
-
Blue (Solid) – Confirms card is a Dante PTP leader; the card is set (via Dante Controller) to generate the Dante clock which will be used by other units
-
Green (Solid) – Confirms card is a Dante PTP follower; the card will sync to the clock embedded in the incoming Dante bitstream
-
Off – No network connection
-
Purple (Solid) – Indicates card is in Switched mode
-
-
Reset Switch
Clears current configuration (Name, IP config, etc.). Press and hold for seven seconds to return the card to its default state with the DHCP setting.
When pressed, the front panel LEDs will illuminate in sequence at one-second intervals. All LEDs will then flash for a further three seconds, after which the card will reset.
-
Primary Network Port
RJ45 connector for the Dante network. Use shielded Cat 5e or better network cables to connect the card to the Ethernet network switch.
Adjacent to both network sockets are LEDs which illuminate to indicate a valid network connection and network activity.
-
Secondary Network Port
Secondary Dante network connection where two independent Ethernet links are being used (Redundant mode), or an additional port on an integral network switch on the primary network (Switched mode). The operating mode is set via Dante Controller.
The Dante network can be viewed or controlled via either port.